nv-l

Re: Map Question

2000-05-25 07:14:16
Subject: Re: Map Question
From: Dave_Finn AT computacenter DOT com
To: nv-l AT lists.tivoli DOT com
Date: Thu, 25 May 2000 12:14:16 +0100
Hi Ronnie,

It's an annoying one, I don't know why it works like this, it would be much
better if the routers went straight into the location submap.  But I am sure
there is a good explanation.

Anyway to sort your problem.

     -    Close down you map.
     -    Shutdown netmon (ovstop netmon)
     -    run ovtopofix -a
     -    Restart netmon

When you now open your map you should be able to cut and paste your routers.

Dave Finn
Enterprise Consultant
Computacenter





ronnie.ross AT springs DOT com on 24/05/2000 21:25:39

Please respond to IBM NetView Discussion <nv-l AT tkg DOT com>




To:   IBM NetView Discussion <nv-l AT tkg DOT com>
cc:    (bcc: Dave Finn/COSS/CCenter)
Subject:  [NV-L] Map Question




I Finally received by copy of V6 and created a locations.conf file and
started up NetView.  When I go into IP Internet, all the Locations were
automatically created, but all the routers are at this level.  If I cut one
and then go into the location that the router belong in and paste, it goes
into the user plane and does not drop down and reconnect the lines back to
all the IP networks at that location.

Is this the way it is supposed to work, or did I miss something?

Ronnie Ross
Network Engineer

_________________________________________________________________________

NV-L List information (unsubscribing, policies, posting, digest version,
searchable archives): http://www.tkg.com/nv-l


<Prev in Thread] Current Thread [Next in Thread>