nv-l

Re: Event values

2000-05-18 11:02:46
Subject: Re: Event values
From: James_Shanks AT tivoli DOT com
To: nv-l AT lists.tivoli DOT com
Date: Thu, 18 May 2000 11:02:46 -0400

What goes into the slot is determine by the slot map values you set in
trapd.conf, assuming you are sending these events to TEC via the internal
adapter.   But you can only set them to constants and variables contained in the
trap itself.  If you want to add new information, then you may have to use a
ruleset to issue a new trap which contains the information you want and send
that one to TEC instead of the first.

James Shanks
Tivoli (NetView for UNIX and NT) L3 Support


"Frank W. Hansen" <fhansen AT mindspring DOT com> on 05/18/2000 11:53:07 AM

Please respond to IBM NetView Discussion <nv-l AT tkg DOT com>

To:   IBM NetView Discussion <nv-l AT tkg DOT com>
cc:    (bcc: James Shanks/Tivoli Systems)
Subject:  [NV-L] Event values




Greetings.  I need the ability to change a TEC slot value within a
NetView event.  For example.  I have defined an event within NetView and
set two slot values to be used with the event.  When I issue an snmptrap
command, is there a way to change what the contents of these slot values
are?  It appears that you have to pre-set these values.  Any ideas?

--

Best Regards,

Frank W. Hansen
Tivoli Certified Enterprise Consultant
www.EnterpriseInnovations.com



Greetings.  I need the ability to change a TEC slot value within a NetView event.  For example.  I have defined an event within NetView and set two slot values to be used with the event.  When I issue an snmptrap command, is there a way to change what the contents of these slot values are?  It appears that you have to pre-set these values.  Any ideas?
-- 

Best Regards,

Frank W. Hansen
Tivoli Certified Enterprise Consultant
www.EnterpriseInnovations.com
 
<Prev in Thread] Current Thread [Next in Thread>