There is a command line email tool on the internet called mailto.exe.  I
have used this in several installations.

Marc Russo (mrusso AT al.iisl DOT com)
International Integrated Solutions, LTD


> -----Original Message-----
> From: William V. (Bill) Evans [SMTP:wvevans AT IBM DOT NET]
> Sent: Thursday, May 20, 1999 8:25 PM
> To:   NV-L AT UCSBVM.ucsb DOT edu
> Subject:      Fw: Event Automation in NetView for WindowNT
>
> NVPLAY will pop up a message and play a WAV file.
>
> As far as I can determine command line e-mail would require a third
> party
> package; MS just isn't into command line capabilities anymore.  I've
> seen a
> hack where you connect to a mail handler node (telnet?) and ship it a
> pre-formatted output stream but didn't save the details.  Look around
> the
> old DOS packages and  you might locate one; probably along with
> Kermit,
> BitCom and other artifacts of the PC world's middle ages.
>
> Bill Evans  --  Consultant and Trainer for 2ndWave (www.2nd-wave.com)
> "Managing the enterprise and beyond"
> reply-to: Bill.Evans AT 2nd-wave DOT com
> Phone: 919-696-7513 FAX: 919-847-4753
> Send short text messages to 9196967513 AT messaging.sprintpcs DOT com
>
>
> -----Original Message-----
> From: Geoffrey Cheng <gcheng AT CA.IBM DOT COM>
> Date: Wednesday, May 19, 1999 8:42 PM
> Subject: Event Automation in NetView for WindowNT
>
>
> >Hi,
> >
> >     In Windows NT, can I send e-mail and paging via command line?
> >     I am thinking about using it to configure the event automation
> (trapd.conf)
> >     on NetView for NT as I used to did on NetView for AIX.
> >
> >     Secondly, is there any equivalent command of ovxbeep in NetView
> for
> NT?
> >
> >     Thanks.
> >
> >
> >
> >Best Regards
> >
> >Geoffrey Cheng
> >e-mail: gcheng AT ca.ibm DOT com
> > << File: Bill Evans.vcf >>