NVPLAY will pop up a message and play a WAV file.

As far as I can determine command line e-mail would require a third party
package; MS just isn't into command line capabilities anymore.  I've seen a
hack where you connect to a mail handler node (telnet?) and ship it a
pre-formatted output stream but didn't save the details.  Look around the
old DOS packages and  you might locate one; probably along with Kermit,
BitCom and other artifacts of the PC world's middle ages.

Bill Evans  --  Consultant and Trainer for 2ndWave (www.2nd-wave.com)
"Managing the enterprise and beyond"
reply-to: Bill.Evans AT 2nd-wave DOT com
Phone: 919-696-7513 FAX: 919-847-4753
Send short text messages to 9196967513 AT messaging.sprintpcs DOT com


-----Original Message-----
From: Geoffrey Cheng <gcheng AT CA.IBM DOT COM>
Date: Wednesday, May 19, 1999 8:42 PM
Subject: Event Automation in NetView for WindowNT


>Hi,
>
>     In Windows NT, can I send e-mail and paging via command line?
>     I am thinking about using it to configure the event automation
(trapd.conf)
>     on NetView for NT as I used to did on NetView for AIX.
>
>     Secondly, is there any equivalent command of ovxbeep in NetView for
NT?
>
>     Thanks.
>
>
>
>Best Regards
>
>Geoffrey Cheng
>e-mail: gcheng AT ca.ibm DOT com
>

Bill Evans.vcf
Description: Vcard