Veritas-bu

[Veritas-bu] SL500 Library - Cannot Be Seen By Master

2009-02-13 11:12:02
Subject: [Veritas-bu] SL500 Library - Cannot Be Seen By Master
From: "WEAVER, Simon \(external\)" <simon.weaver AT astrium.eads DOT net>
To: <veritas-bu AT mailman.eng.auburn DOT edu>
Date: Fri, 13 Feb 2009 15:57:10 -0000

Hi All
This is generally a question for anyone that has an SL500 and used with Windows (If poss).

I had an Engineer installed the library, and I have installed into the fabric 1 robot and 6 LTO4 Drives.

According to the Cisco Management Software, it should be seen by the Master Server. However, Device Manager cannot see jack all.

Initiating the NetBackup command shows the current HP Library and LTO3 drives.

Looking at the SL500 Library Console, I cannot see anything about configuring anything to allow the Master Server to see the Tape Drives (which I do have on the ESL HP Library).

Anyone used one of these devices and offer any advice, while I trawl through their Java PDF !?!

Thanks, Simon

This email (including any attachments) may contain confidential
and/or privileged information or information otherwise protected
from disclosure. If you are not the intended recipient, please
notify the sender immediately, do not copy this message or any
attachments and do not use it for any purpose or disclose its
content to any person, but delete this message and any attachments
from your system. Astrium disclaims any and all liability if this
email transmission was virus corrupted, altered or falsified.
-o-
Astrium Limited, Registered in England and Wales No. 2449259
Registered Office:
Gunnels Wood Road, Stevenage, Hertfordshire, SG1 2AS, England
_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu