Re: [Networker] SV: [Networker] Q about automatically labeling tape based on barcode
2013-09-13 06:12:34
On Friday 13 September 2013 07:03:57 Tony Albers wrote:
> Hi Michael,
>
> AFAIK you can't choose to only label "some" tapes in the library when using
> auto-labeling. If some of the barcodes are unreadable, you will run into
> errors.
>
> What you could do, is partition your library and then set one up with
> auto-labeling and have the other one use all the old tapes using the old
> standards.
>
> You could of course also consider staging all savesets from all the old tapes
> to new tapes with correct barcodes, but that might involve quite a lot of
> work ;)
I wouldn't expect problems with the old tapes even if you turn on "Match
barcodes". Not as
long as you don't try to relabel/recycle them. This as the setting is applied
during the
labeling process.
But I could be wrong...
Best
Dag
|
|
|