Re: [Bacula-users] File deamon not following configuration
2013-06-14 03:04:41
OK just checked on this.
When entering this command I get a list of a couple thousand volumes. I
think I should invalidate/clear them all. Heading of the table rolls
right off the screen so no idea what the numbers mean!
Wouter.
On Wed, 2013-05-15 at 12:21 +0200, Radosław Korzeniewski wrote:
> Hello,
>
>
> 2013/5/15 Wouter van Marle <wouter AT squirrel-systems DOT com>
> Hereby example of a message from a job. It seems to be
> recycling a
> volume, even though I have set "Recycle = no" in
> bacula-dir.conf!
>
>
> Show output of the bconsole command (the pool name is the pool
> resource where your recycled volume is assigned, put below a valid
> one):
> * list media pool=File
>
>
> Then check if recycle parameter is set to '0' or '1' for this
> particular volume. If it is setup to '1' then you can update this flag
> with "update" command.
>
>
> best regards
> --
> Radosław Korzeniewski
> radoslaw AT korzeniewski DOT net
------------------------------------------------------------------------------
This SF.net email is sponsored by Windows:
Build for Windows Store.
http://p.sf.net/sfu/windows-dev2dev
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- Re: [Bacula-users] File deamon not following configuration,
Wouter van Marle <=
|
|
|