Re: [Bacula-users] concurrent jobs on the same storage
2010-02-24 09:03:33
On Wed, Feb 24, 2010 at 8:07 AM, Silver Salonen <silver AT ultrasoft DOT ee>
wrote:
> On Tuesday 23 February 2010 19:09:49 Phil Stracchino wrote:
>> On 02/23/10 06:32, Silver Salonen wrote:
>> > I consider it a bug, but looks like devs do not. Any opinions?
>>
>> I ran into this problem when I first upgraded to 3.0.3. It turned out
>> to be a configuration issue. Make sure you have the desired level of
>> concurrency enabled in ALL applicable resources (i.e, you need "Maximum
>> Concurrent Jobs = 20" set for the SD both in your bacula-sd.conf file
>> AND in your bacula-dir.conf file). If you have different values set in
>> different places, the *lowest* will end up being used.
>
> Do I get it right, that you have multiple jobs using the same device
> concurrently?
>
I have had this work for over 5 years with bacula. Jobs need to go to
the same volume however because a storage device can only load a
single volume. I use tape mostly so I do not see this as a big issue.
I have a multi-drive autochanger that takes care of using different
volumes concurrently.
John
------------------------------------------------------------------------------
Download Intel® Parallel Studio Eval
Try the new software tools for yourself. Speed compiling, find bugs
proactively, and fine-tune applications for parallel performance.
See why Intel Parallel Studio got high marks during beta.
http://p.sf.net/sfu/intel-sw-dev
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users
|
|
|