On Sat, Jun 28, 2008 at 8:32 AM, James Bowes <james.bowes AT shaw DOT ca> wrote:
> Hi.
>
> I have had so much problems I decided to start over with the btape
> tests. Now I am getting errors for autochanger. What does this actually
> mean:
>
> 28-Jun 05:27 btape JobId 0: Error: block.c:569 Write error at 0:295 on
> device "DLT" (/dev/nst0). ERR=Input/output error
>
If this is not an end of tape situation this is usually a hardware
problem like a bad tape or scsi errors. Do you have any messages in
your dmesg output pertaining to st or your scsi controller?

John

-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users