Re: [Bacula-users] Volumes in the wrong Pools is this a known issue? ver 2.0.3
2008-06-18 12:42:54
On Wed, Jun 18, 2008 at 12:25 PM, Keith Sudbury
<keith AT netzensolutions DOT com> wrote:
> I have had this issue with Bacula I will label a tape "wednesday" put it
> in "wed-pool" the correct pool. every thing is fine, then when I come to
> use the tape I insert it mount it and I get the following:
>
> Device status:
> Device "LTO-3" (/dev/nst0) is mounted with Volume="wednesday"
> Pool="tue-pool"
> Total Bytes Read=129,024 Blocks Read=2 Bytes/block=64,512
> Positioned at File=0 Block=0
>
>
> Any ideas why it is doing this? I am using the packaged version from the
> EPEL repo http://fedoraproject.org/wiki/EPEL
>
I found that when this happens the volume is in the correct pool but
the Pool listed in the status is not correct.
John
-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users
|
|
|