I am trying to complete a restore and let the restore go for two days. When I 
went to troubleshoot I found that by running the command "lsof | grep rsync" I 
could see the current file it was trying to restore and it was hung on this 
file. However, when I try to run restore again, it just ends up hanging on a 
different file. Any assistance to figure out what is going on would be 
appreciated. I am currently on version 3.3.1 of BackupPC. The rsync version on 
BackupPC server is rsync  version 3.1.2pre1. The rsync version on the target 
server is rsync  version 3.0.6.

+----------------------------------------------------------------------
|This was sent by robp2175 AT hotmail DOT com via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------



------------------------------------------------------------------------------
What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic
patterns at an interface-level. Reveals which users, apps, and protocols are 
consuming the most bandwidth. Provides multi-vendor support for NetFlow, 
J-Flow, sFlow and other flows. Make informed decisions using capacity planning
reports.http://sdm.link/zohodev2dev
_______________________________________________
BackupPC-users mailing list
BackupPC-users AT lists.sourceforge DOT net
List:    https://lists.sourceforge.net/lists/listinfo/backuppc-users
Wiki:    http://backuppc.wiki.sourceforge.net
Project: http://backuppc.sourceforge.net/