BackupPC-users

Re: [BackupPC-users] TIMEOUT on SMB causes missed files and undetected partial.

2012-02-25 10:09:35
Subject: Re: [BackupPC-users] TIMEOUT on SMB causes missed files and undetected partial.
From: Steve <jelloskins AT gmail DOT com>
To: "General list for user discussion, questions and support" <backuppc-users AT lists.sourceforge DOT net>
Date: Sat, 25 Feb 2012 09:07:47 -0600


On Wed, Feb 22, 2012 at 10:09 AM, Pedro M. S. Oliveira <pmsoliveira AT gmail DOT com> wrote:

Hello,
I would advise you to use the rsync method on Windows as it's less tricky than smb.
There's an how to at
www.linux-geex.com
Just search for backuppc on the search field.
Cheers
Pedro Oliveira

On Feb 22, 2012 2:29 PM, "Steve" <jelloskins AT gmail DOT com> wrote:


On Mon, Feb 13, 2012 at 2:07 PM, Les Mikesell <lesmikesell AT gmail DOT com> wrote:
On Mon, Feb 13, 2012 at 1:33 PM, Steve <jelloskins AT gmail DOT com> wrote:
I am backing a Windows XP PC that is remote (Internet) and it takes several hours. I am selectively backing up a small amount of data. Somewhere in the middle of the backup, I start getting lines like these:

NT_STATUS_CONNECTION_INVALID listing \ramu\*
NT_STATUS_CONNECTION_INVALID listing \temp\*
NT_STATUS_CONNECTION_INVALID listing \temp_wks_5418\*
Once I get these lines, they seem to be continues for every subfolder and the files do not get backed up.
Additionally, those lines are always preceded by a line like this:
Error reading file \backup\Canon_2GB_SDC\dvd-backup\sees\msp430\MSP430_Console_IAR_STD\timerb.c : NT_STATUS_IO_TIMEOUT
Which is sometimes a large file but often a small file.
The worst part of this is that the backup misses the remaining data AND gets flagged as "Full" and not "Partial". Therefore Backuppc won't try to continue or do any more with that PC until next week. See the 14917 Xfer errs below.

I've seen that happen where there was a duplex mismatch between the target host and its switch connection (one configured for 'full', one for "auto", but  full means "don't negotiate" and auto means "assume half if there is no negotiation").  Any bad network connection could probably cause it.  I'd agree that it should probably be interpreted as a more fatal error.

--
   Les Mikesell
      lesmikesell AT gmail DOT com


No new news on this. It still happens and I haven't been able to figure it out. The network topology is this:

Windows PC  -> (10.10.0.?) SonicWallVPN Client -> Internet -> SonicWall VPN Router (10.10.0.1) -> BackupPC on Linux-x64 (10.10.0.12)

------------------------------------------------------------------------------
Virtualization & Cloud Management Using Capacity Planning
Cloud computing makes use of virtualization - but cloud computing
also focuses on allowing computing to be delivered as a service.
http://www.accelacomm.com/jaw/sfnl/114/51521223/
_______________________________________________
BackupPC-users mailing list
BackupPC-users AT lists.sourceforge DOT net
List:    https://lists.sourceforge.net/lists/listinfo/backuppc-users
Wiki:    http://backuppc.wiki.sourceforge.net
Project: http://backuppc.sourceforge.net/


Thanks. I will check timeouts and also check on using rsync. I think rsync would also do better for continuing partials, correct?
------------------------------------------------------------------------------
Virtualization & Cloud Management Using Capacity Planning
Cloud computing makes use of virtualization - but cloud computing 
also focuses on allowing computing to be delivered as a service.
http://www.accelacomm.com/jaw/sfnl/114/51521223/
_______________________________________________
BackupPC-users mailing list
BackupPC-users AT lists.sourceforge DOT net
List:    https://lists.sourceforge.net/lists/listinfo/backuppc-users
Wiki:    http://backuppc.wiki.sourceforge.net
Project: http://backuppc.sourceforge.net/