On Thu, Feb 10, 2011 at 3:25 PM, Bowie Bailey <Bowie_Bailey AT buc DOT com> 
wrote:
>
> The only machines I have that make use of that command only have one
> share, so I can't say from experience.  But reading the docs, that
> should not happen.  I believe the order should be like this:
>
> Run DumpPreUserCmd
> Run DumpPreShareCmd
> Dump Share 1
> Run DumpPostShareCmd
> Run DumpPreShareCmd
> Dump Share 2
> Run DumpPostShareCmd
> Run DumpPostUserCmd
>

Actually that is the problem.  I need the command to run at then end
of all the jobs, not just individual dumps.

I discovered in the manual that "archive" is a specific xfer method
which explains why the ArchivePostUserCmd didn't function with rsync.

I may be forced to monitor output from BackupPC_serverMesg to pick out
active jobs and shut down when there aren't any.

------------------------------------------------------------------------------
The ultimate all-in-one performance toolkit: Intel(R) Parallel Studio XE:
Pinpoint memory and threading errors before they happen.
Find and fix more than 250 security defects in the development cycle.
Locate bottlenecks in serial and parallel code that limit performance.
http://p.sf.net/sfu/intel-dev2devfeb
_______________________________________________
BackupPC-users mailing list
BackupPC-users AT lists.sourceforge DOT net
List:    https://lists.sourceforge.net/lists/listinfo/backuppc-users
Wiki:    http://backuppc.wiki.sourceforge.net
Project: http://backuppc.sourceforge.net/