Problems accessing my new autoloader
2007-11-22 11:30:28
Hi,
meanwhile I got my new Tandberg StorageLoader 2U LTO3 Autoloader. But I'm
having problems to use it. Maybe some of you can give me a hint:
I tried to label one of the tapes by hand:
# amlabel KAS KAS001 slot 10
labeling tape in slot 10 (/dev/tape):
rewinding, reading label, not an amanda tape
rewinding, writing label KAS001, checking label
amlabel: no label found, are you sure /dev/tape is non-rewinding?
amlabel.*.debug just says:
amlabel: time 125.466: no label found, are you sure /dev/tape is non-rewinding?
/dev/tape is a symlink to nst0:
# ls -la /dev/tape
lrwxrwxrwx 1 root root 4 21. Nov 20:17 /dev/tape -> nst0
Using mt shows, that the tape is online, when it's loaded into the drive:
# mt -f /dev/tape status
drive type = Generic SCSI-2 tape
drive status = 1140850688
sense key error = 0
residue count = 0
file number = 0
block number = 1
Tape block size 0 bytes. Density code 0x44 (unknown).
Soft error count since last status=0
General status bits on (1010000):
ONLINE IM_REP_EN
I use a selfcompiled amanda 2.5.2p1 on openSUSE 10.3 with the included mtx
1.2.18rel-191.
Regards
Marc
--
Marc Muehlfeld (Leitung Systemadministration)
Zentrum fuer Humangenetik und Laboratoriumsmedizin Dr. Klein und Dr. Rost
Lochhamer Str. 29 - D-82152 Martinsried
Telefon: +49(0)89/895578-0 - Fax: +49(0)89/895578-78
http://www.medizinische-genetik.de
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- Problems accessing my new autoloader,
Marc Muehlfeld <=
|
|
|