Quick question will Amanda work correctly with two different
configurations, each one using a tape drive running at the same time?
Ex.
Data Transfer Element 0:Empty
Data Transfer Element 1:Full (Storage Element 9
Loaded):VolumeTag = EGV010 these are my 2 drives.
However,
When I try to run
/opt/amanda/server/sbin/amlabel -f FullDB EGV010 slot 9
Here is the error I get
“amlabel: could not load slot "9": Drive not
ready after 120 seconds, rewind said "/dev/rmt/3cn:"Drive not ready
after no seconds, rewind said "tape"Drive not ready after loaded
seconds, rewind said "or"Drive not ready after drive seconds, rewind
said "offline"”
The tape EGV010 always goes to drive 0 instead of 1.
mtx -f /dev/scsi/changer/c5t3d1 status
Storage Changer /dev/scsi/changer/c5t3d1:2 Drives, 24
Slots ( 1 Import/Export )
Data Transfer Element 0:Full (Storage Element 9
Loaded):VolumeTag = EGV010
Here are the conf files for FullDB
cat changer.conf
firstslot=1
lastslot=23
driveslot=1
cleanslot=-1
autoclean=0
autocleancount=99
havereader=1
offline_before_unload=0
initial_poll_delay=0
tapedev "/dev/rmt/3cn" # the no-rewind tape
device to be used ***Currently using hardware compression
changerdev "/dev/scsi/changer/c5t3d1"
amrecover_changer "/dev/scsi/changer/c5t3d1"
Thanks
