Re: mutiple network interfaces
2007-10-09 14:24:27
Krahn, Anderson wrote:
How do I tell Amanda to use a specific network interface if 2 exist on
the system.
For instance I would like Amanda to only use the ce4 interface..
ce0: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index 2
inet 10.20.1.181 netmask ffff0000 broadcast 10.20.255.255
ether 0:3:ba:9a:4f:6f
ce4: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index 3
inet 172.23.1.73 netmask ffffff00 broadcast 172.23.1.255
ether 0:3:ba:9a:4f:6f
this ought not to be an amanda issue, but rather an OS level routing issue.
if you ask amanda to backup computer blah.your.private.net, then your
routing should direct the traffic through ce4. If you ask it to do
blah1.your.other.net, then it should go through ce0. Your hostname
resolution needs to resolve in such a way as to direct the traffic.
if you post more information about your OS and network configuration,
someone might accidentally be able to help.
I note that the ethernet address of both ce0 and ce4 is the same. So
they are virtual interfaces going out on the same wire.
---------------
Chris Hoogendyk
-
O__ ---- Systems Administrator
c/ /'_ --- Biology & Geology Departments
(*) \(*) -- 140 Morrill Science Center
~~~~~~~~~~ - University of Massachusetts, Amherst
<hoogendyk AT bio.umass DOT edu>
---------------
Erdös 4
|
|
|