amcheck test
2006-04-05 13:09:00
I have set up a test environment using vtapes following the
instructions to the letter as shown in:
http://wiki.zmanda.com/index.php/Test_environment_with_virtual_tapes
#
# /etc/amanda/test/amanda.conf
#
org "Parasol Laboratory"
mailto "enricoi AT cs.tamu DOT edu"
dumpcycle 7
runspercycle 5
tapecycle 5
dumpuser "amanda"
tpchanger "chg-disk" # a virtual tape changer
tapedev "file:/space/vtapes/test/slots"
changerfile "/var/lib/amanda/test/changerfile"
Questions:
'amcheck test' has run without error messages except for today:
Amanda Tape Server Host Check
-----------------------------
Holding disk /space/amandahold/test: 356151020 kB disk space
available, using 356151020 kB
amcheck-server: slot 3: date 20060401 label TEST-3 (active tape)
amcheck-server: slot 4: date 20060404 label TEST-4 (active tape)
amcheck-server: slot 5: date 20060405 label TEST-5 (active tape)
amcheck-server: slot 1: not an amanda tape
amcheck-server: slot 2: date 20060331 label TEST-2 (active tape)
ERROR: new tape not found in rack
(expecting a new tape)
NOTE: skipping tape-writable test
WARNING: tapecycle (5) <= runspercycle (5).
NOTE: info dir /var/lib/amanda/test/curinfo/gemenon: does not exist
NOTE: it will be created on the next run.
NOTE: index dir /var/lib/amanda/test/index/gemenon: does not exist
NOTE: it will be created on the next run.
Server check took 0.394 seconds
Amanda Backup Client Hosts Check
--------------------------------
Client check: 4 hosts checked in 0.109 seconds, 0 problems found
(brought to you by Amanda 2.4.5)
I guess that that amanda is not able to reuse tape 1. Correct guess?
If yes, why not? The tapecycle=5, thus amanda should know that it
needs to go back to 1 after 5 and I have labelled all of them at the
beginning using amlabel.
I am setting up an 'archive' configuration for full backup to tape. I
am trying to understand the changer configuration.
I did not create any file in /var/lib/amanda/test, but amanda created:
changerfile-access
changerfile-clean
changerfile-slot
However, there is no /var/lib/amanda/test/changerfile as the example
has in amanda.conf.
I have a /dev/sg1 medium changer, Quantum Autoloader
/usr/sbin/mtx -f /dev/sg1 inquiry
Product Type: Medium Changer
Vendor ID: 'QUANTUM '
Product ID: 'UHDL '
Revision: '0023'
Attached Changer: No
I suppose I have to use /usr/lib/amanda/chg-zd-mtx
I see that the file has to be edited to reflect my specific situation.
Do I then move the file to /var/lib/amanda/archive and define this in
/etc/amanda/archive/amanda.conf?
The documentation is not very clear on this.
Thanks to all.
--
Enrico Indiogine
Parasol Laboratory
Texas A&M University
enricoi AT cs.tamu DOT edu
hindiogine AT gmail DOT com
979-845-3937
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- amcheck test,
Salvatore Enrico Indiogine <=
|
|
|