On 2006-04-03 16:51, stan wrote:
If I'm using chg-multi, the tape device(s) are defiend in it's config file.
Given that do I even need to set tapdev in amanda.conf?
Form the Example found in the wiki:
http://wiki.zmanda.com/index.php/File_driver#Virtual_tapes_with_chg-multi
tpchanger "chg-multi"
changerfile "chg-multi.conf" # name of the special configuration file
# tapedev is ignored if present, to avoid confusion, just comment it out
# changerdev is ignored too
--
Paul Bijnens, xplanation Technology Services Tel +32 16 397.511
Technologielaan 21 bus 2, B-3001 Leuven, BELGIUM Fax +32 16 397.512
http://www.xplanation.com/ email: Paul.Bijnens AT xplanation DOT com
***********************************************************************
* I think I've got the hang of it now: exit, ^D, ^C, ^\, ^Z, ^Q, ^^, *
* F6, quit, ZZ, :q, :q!, M-Z, ^X^C, logoff, logout, close, bye, /bye, *
* stop, end, F3, ~., ^]c, +++ ATH, disconnect, halt, abort, hangup, *
* PF4, F20, ^X^X, :D::D, KJOB, F14-f-e, F8-e, kill -1 $$, shutdown, *
* init 0, kill -9 1, Alt-F4, Ctrl-Alt-Del, AltGr-NumLock, Stop-A, ... *
* ... "Are you sure?" ... YES ... Phew ... I'm out *
***********************************************************************
|