On Sunday 19 February 2006 16:51, Ross Vandegrift wrote:
>Hello everyone,
>
>When I do a local restore on a backup server with amrecover, I get
>prompted to change tapes when it is required:
>
>Extracting files using tape drive /dev/null on host linuxbackup1.
>Load tape DailySet102 now
>Continue [?/Y/n/t]?"
>
>I can then press "t" and set the tape correctly.
>
>
>However, when I do a remote restore with amrecover, I get a different
>prompt:
>
>Load tape DailySet113 now
>Continue? [Y/n]:
>
>This is fine for a restore that requires a single tape, since I can
>use settape and the extract a second time. However, restores
>requiring multiple tapes will always fails, since I can't change tapes
>in the middle of the restore.
>
>I've verified that the remote server is correctly configured in
>.amandahosts for access.
>
>
>The only difference I can see between the two installation is that the
>backup server runs 2.4.5, while the remote server runs 2.4.2p2. Was
>this feature added in between these versions?
About all I can recommend is to check the ChangeLog in your 2.4.5
srcdir.
--
Cheers, Gene
People having trouble with vz bouncing email to me should add the word
'online' between the 'verizon', and the dot which bypasses vz's
stupid bounce rules. I do use spamassassin too. :-)
Yahoo.com and AOL/TW attorneys please note, additions to the above
message by Gene Heskett are:
Copyright 2006 by Maurice Eugene Heskett, all rights reserved.
|