Re: Amanda config for two drives
2005-01-13 16:28:36
On Thu, 2005-01-13 at 15:50 -0500, Jon LaBadie wrote:
> On Thu, Jan 13, 2005 at 12:06:56PM -0500, Vicki Stanfield wrote:
> > > I would be amazed that amcheck did not complain :-)
> >
> > It hasn't yet been given the chance to. :-)
>
> Should be the first thing after any config changes.
If you are ready to deploy. In this case the other tape drive was on
order, so I made the changes in a copied config file.
>
> >
> > Okay, so I knew that I needed to use the chg-multi changer, but I was
> > unsure as to how. I have found some more information, but I don't know
> > where to get the script. I saw reference to it in an example directory
> > somewhere. I can't find it though.
>
> It is an included component of an amanda install. In my case it installed
> in /usr/local/libexec. YMMV
>
> jl
Thanks. I found it now. Now the follow on question is: is there a way to
tell amanda to rerun the backup that it just ran just in case it doesn't
work? Or is it as simple as running the backup command again? I assume
that it changes the states of the backups each time to prevent the full
backup of everything in the disklist. If the state information has been
updated, is there a way to rerun exactly what was run before?
Thanks,
Vicki
|
|
|