Re: Removing / replacing tape in cycle
2005-01-10 01:18:30
Hi,
after trying this and this morning and
getting even more confused, I just found out that the tape was faulty.
I inserted an new one, labeled it tape21
(my tapecycle is from tape1 to tape20), ran amflush and everything is working
fine. But know the next question.
How do I get the faulty one replaced
by the new one ?
I can´t use a scratch file from the
old one, as the header is not readable anymore. The tape gone bad was tape11.
Any help is highly appreciated.
Thanks in advance.
Sandra Krumme
|
|
|