Amanda-Users

Re: Strange Error - Again :/// dmesg

2003-11-03 15:48:35
Subject: Re: Strange Error - Again :/// dmesg
From: Roberto Samarone Araújo (RSA) <rsa AT gr.iesam-pa.edu DOT br>
To: <amanda-users AT amanda DOT org>
Date: Mon, 3 Nov 2003 17:51:25 -0800
This is my dmesg.



-----



Linux version 2.4.21 (root AT ananin.iesam.com DOT br) (gcc version 2.95.4 
20011002
(Debian prerelease)) #3 Thu Oct 23 09:20:02 BRT 2003
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 00000000000a0000 (usable)
 BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 0000000007800000 (usable)
 BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved)
120MB LOWMEM available.
On node 0 totalpages: 30720
zone(0): 4096 pages.
zone(1): 26624 pages.
zone(2): 0 pages.
Kernel command line: BOOT_IMAGE=Linux ro root=302
Initializing CPU#0
Detected 533.486 MHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 1061.68 BogoMIPS
Memory: 118848k/122880k available (1472k kernel code, 3648k reserved, 388k
data, 240k init, 0k highmem)
Dentry cache hash table entries: 16384 (order: 5, 131072 bytes)
Inode cache hash table entries: 8192 (order: 4, 65536 bytes)
Mount cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer-cache hash table entries: 4096 (order: 2, 16384 bytes)
Page-cache hash table entries: 32768 (order: 5, 131072 bytes)
CPU: L1 I Cache: 32K (32 bytes/line), D cache 32K (32 bytes/line)
CPU:     After generic, caps: 008021bf 808029bf 00000000 00000002
CPU:             Common caps: 008021bf 808029bf 00000000 00000002
CPU: AMD-K6(tm) 3D processor stepping 0c
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
PCI: PCI BIOS revision 2.10 entry at 0xfb4b0, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Using IRQ router VIA [1106/0686] at 00:07.0
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
Journalled Block Device driver loaded
NTFS driver v1.1.22 [Flags: R/O]
Detected PS/2 Mouse Port.
pty: 256 Unix98 ptys configured
tpqic02: IRQ 5, DMA 1, IO 0x300, IFC Wangtek, $Revision: 1.10 $, $Date: 1997
/01/26 07:13:20 $
tpqic02: Settings: IRQ 5, DMA 1, IO 0x300, IFC Wangtek
tpqic02: reset failed!
tpqic02: No drive detected -- releasing IO/IRQ/DMA.
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ
SERIAL_PCI ISAPNP enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
loop: loaded (max 8 devices)
PCI: Found IRQ 12 for device 00:0a.0
3c59x: Donald Becker and others. www.scyld.com/network/vortex.html
See Documentation/networking/vortex.txt
00:0a.0: 3Com PCI 3c905C Tornado at 0xe000. Vers LK1.1.16
 00:01:03:d4:68:c0, IRQ 12
  product code 4b53 rev 00.3 date 02-08-01
  Internal config register is 1800000, transceivers 0xa.
  8K byte-wide RAM 5:3 Rx:Tx split, autoselect/Autonegotiate interface.
  MII transceiver found at address 24, status 7809.
  Enabling bus-master transmits and whole-frame receives.
00:0a.0: scatter/gather enabled. h/w checksums enabled
Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
hda: Maxtor 2B020H1, ATA DISK drive
hdb: SAMSUNG SV2011H, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: attached ide-disk driver.
hda: host protected area => 1
hda: 39062500 sectors (20000 MB) w/2048KiB Cache, CHS=2431/255/63
hdb: attached ide-disk driver.
hdb: host protected area => 1
hdb: 39179952 sectors (20060 MB) w/2048KiB Cache, CHS=2438/255/63
Partition check:
 hda: hda1 hda2 hda3 < hda5 hda6 >
 hdb: hdb1
SCSI subsystem driver Revision: 1.00
PCI: Found IRQ 10 for device 00:09.0
scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.8
        <Adaptec 29160 Ultra160 SCSI adapter>
        aic7892: Ultra160 Wide Channel A, SCSI Id=10, 32/253 SCBs

  Vendor: SONY      Model: SDT-9000          Rev: 0601
  Type:   Sequential-Access                  ANSI SCSI revision: 02
(scsi0:A:5): 3.300MB/s transfers
st: Version 20020805, bufsize 32768, wrt 30720, max init. bufs 4, s/g segs
16
Attached scsi tape st0 at scsi0, channel 0, id 5, lun 0
mice: PS/2 mouse device common for all mice
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 8192 bind 8192)
ip_tables: (C) 2000-2002 Netfilter core team
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
kjournald starting.  Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem) readonly.
Freeing unused kernel memory: 240k freed
Adding Swap: 128484k swap-space (priority -1)
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,2), internal journal
kjournald starting.  Commit interval 5 seconds
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,5), internal journal
EXT3-fs: mounted filesystem with ordered data mode.
kjournald starting.  Commit interval 5 seconds
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,6), internal journal
EXT3-fs: mounted filesystem with ordered data mode.
kjournald starting.  Commit interval 5 seconds
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,65), internal journal
EXT3-fs: mounted filesystem with ordered data mode.





<Prev in Thread] Current Thread [Next in Thread>
  • Re: Strange Error - Again :/// dmesg, Roberto Samarone Araújo (RSA) <=