Raymond Keckler wrote:
I changed the runtapes to 5 and it still will not change tapes. IT
fills up the first one and then runs out of tape. I am wondering why the
next tape it says it needs to use is "a new tape" instead of a tape
label.
These dumps were to tape daily24.
*** A TAPE ERROR OCCURRED: [[new tape not found in rack]].
Some dumps may have been left in the holding disk.
Run amflush to flush them to tape.
The next 5 tapes Amanda expects to used are: a new tape, a new tape, a
new tape, a new tape, a new tape.
Question was already asked, but not aswered. What are the settings
in amanda.conf about your changer?
(e.g. Are you using the changer, or are you just using /dev/rmt/0 instead?)
--
Paul Bijnens, Xplanation Tel +32 16 397.511
Technologielaan 21 bus 2, B-3001 Leuven, BELGIUM Fax +32 16 397.512
http://www.xplanation.com/ email: Paul.Bijnens AT xplanation DOT com
***********************************************************************
* I think I've got the hang of it now: exit, ^D, ^C, ^\, ^Z, ^Q, F6, *
* quit, ZZ, :q, :q!, M-Z, ^X^C, logoff, logout, close, bye, /bye, *
* stop, end, F3, ~., ^]c, +++ ATH, disconnect, halt, abort, hangup, *
* PF4, F20, ^X^X, :D::D, KJOB, F14-f-e, F8-e, kill -1 $$, shutdown, *
* kill -9 1, Alt-F4, Ctrl-Alt-Del, AltGr-NumLock, Stop-A, ... *
* ... "Are you sure?" ... YES ... Phew ... I'm out *
***********************************************************************
|