Re: [ADSM-L] V6 selectable tables question
2009-05-07 14:31:04
I agree with Howard- at least you see the selects in the actlog. And
the dsmadmc is part of the product, and uses the documented ports which
are opened for firewall access.
As a point of information, I have no problems with new releases of TSM
adding to existing tables and showing new tables selectable via dsmadmc.
For existing tables, I prefer to have the new columns at the end of the
existing columns, as seen by select * from table.
Also, I don't see IC60909 on ibm.com.
Any chance the sequence issue when select * from actlog will be
addressed in 6.1.2.0 ?
Thanks
Richard
-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf Of
Howard Coles
Sent: Thursday, May 07, 2009 1:55 PM
To: ADSM-L AT VM.MARIST DOT EDU
Subject: Re: [ADSM-L] V6 selectable tables question
So . . . wouldn't it be a good idea for all the columns and tables to be
viewable through the Admin interface instead? With all the potential
issues for getting the information directly from the db, wouldn't it be
better to just extend the admin interface to provide the info? I'm just
thinking out loud.
See Ya'
Howard
The information contained in this transmission may contain privileged and
confidential information.
It is intended only for the use of the person(s) named above. If you are not
the intended
recipient, you are hereby notified that any review, dissemination, distribution
or
duplication of this communication is strictly prohibited. If you are not the
intended recipient,
please contact the sender by reply email and destroy all copies of the original
message.
To reply to our email administrator directly, please send an email to
postmaster AT sbsplanet DOT com.
|
|
|