Kurt
Thanks again!
regards,
Tim
Kurt Beyers wrote:
> Thimoty,
>
> The 'wait=yes' is required to make sure that the process is started in the
> foreground. If it is started in the background, the processes will be started
> in parallel even with the SERIAL parameter in the script. I found this out
> using it in a script that started multiple exports. As an export cannot be
> started in the foreground, all of them started in parallel.
>
> If you know what backup session will be running as the last, you could start
> an administrative schedule here as a post-exec command. But I guess that it
> is hard to tell which job will finish as the last one.
>
> best regards,
> Kurt
>
> ________________________________
>
> Van: ADSM: Dist Stor Manager namens Timothy Hughes
> Verzonden: ma 24/04/2006 20:39
> Aan: ADSM-L AT VM.MARIST DOT EDU
> Onderwerp: [ADSM-L] New Migrate command
>
> Hello all,
>
> I have a question regarding the 5.3 Migrate Command I have the
> command set up for
>
> Migrate stgpool backuppool lowmig=0
>
> From what I read this command cannot be used with automatic
> migration. I am assuming they mean it cannot run at the same time as
> automatic migration?
>
> Also, I have House Keeping tasks that I have setup using the
> Administrative command schedule sometimes, I have to adjust the
> schedule several times a week so I am planning to implement the
> script below with the new serial commands only. I want the tasks to
> start only after the previous tasks are complete. I have tested this
> already and it worked. my question is since the serial command is in
> there is the wait=yes really necessary as shown in the admin manual
> Also, is there a way to set this script up to start automatically after
> the backup's end?
>
> /*script: Backuppool STGPOOL
>
> /* Backup Diskpool to tape*/
>
> /* previous command must finish before proceeding
> /* with next command in sequence/
>
> Serial
> BA STG backuppool R359XPOOL maxpr=xx preview=no wait=yes
>
> /* Start Disk pool migration*/
> Serial
>
> migrate stgpool backuppool lowmig=0
>
> Serial
>
> /* Backup pool (L359Xpool) to R359Xpool*\
>
> BA STG L359XPOOL R359XPOOL maxpr=xx preview=no wait=yes
>
> TSM 5.3.2
>
> Thanks in Advance!
|