Has anyone seen a pkthread error?
We've upgraded from 3.1 to TSM 4.1.1.0 and keep getting this error that
hangs the server.  It's not running and it's not down completely.  If it
were down, our monitoring would pick that up.

7 servers have been upgraded, but only a couple are having this problem on a
regular basis.
Any thoughts would be greatly appreciated.

> -----Original Message-----
> From: Miller, Ryan [SMTP:Miller.Ryan AT PRINCIPAL DOT COM]
> Sent: Thursday, April 12, 2001 3:33 PM
> To:   ADSM-L AT VM.MARIST DOT EDU
> Subject:      Re: Dr. Watson in NT after installing TSM4.1
>
> The one I can remember off the top of my head is the Fstypes option, it is
> no longer supported and if it is in the OPT file, it will cause Dr Watson.
> I believe we had another non supported option cause the same problem, but
> I can't remember it.  Sorry.  I would review any OPT file you are going to
> copy and question any options that seam out of place. That's how we found
> ours.
>
> -----Original Message-----
> From: LeBlanc, Patricia [mailto:Patricia.Leblanc AT LIBERTYMUTUAL DOT COM]
> Sent: Thursday, April 12, 2001 2:21 PM
> To: ADSM-L AT VM.MARIST DOT EDU
> Subject: Re: Dr. Watson in NT after installing TSM4.1
>
>
> What are the options you are talking about that are no longer supported??
>
> > -----Original Message-----
> > From: Miller, Ryan [SMTP:Miller.Ryan AT PRINCIPAL DOT COM]
> > Sent: Thursday, April 12, 2001 3:13 PM
> > To:   ADSM-L AT VM.MARIST DOT EDU
> > Subject:      Re: Dr. Watson in NT after installing TSM4.1
> >
> > Did you use the original OPT file?  If so, there are some options that
> can
> > cause Dr Watson errors.  They are options that are no longer supported
> by
> > the newer client, we have experienced this issue also and found this
> > cause.
> >
> > -----Original Message-----
> > From: Gottfried Scheckenbach
> > [mailto:gottfried.scheckenbach AT xtelligent DOT de]
> > Sent: Thursday, April 12, 2001 11:24 AM
> > To: ADSM-L AT VM.MARIST DOT EDU
> > Subject: Re: Dr. Watson in NT after installing TSM4.1
> >
> >
> > Because there where no answers:
> >
> > Today I had the same problem - after upgrading a old ADSM 3.1 to TSM 4.1
> > installation on NT with SP 3. Just after installation of SP 6 all went
> > fine.
> >
> > Regards,
> > Gottfried
> >
> >
> > Shekhar Dhotre wrote:
> > >
> > > Hi all ,
> > >
> > > I   installed TSM server 4.1  on WINNT 4.0 service pack 4 , RAM 256 MB
> > > whenever i  open configuration wizard   to configure any of the
> > parameters in
> > > TSM
> > > DR. WATSON  shows his face ..  what should i check to correct this
> > problem ..
> > >
> > > Thanks
> > > shekhar