Re: Dr. Watson in NT after installing TSM4.1
2001-04-12 15:20:47
What are the options you are talking about that are no longer supported??
> -----Original Message-----
> From: Miller, Ryan [SMTP:Miller.Ryan AT PRINCIPAL DOT COM]
> Sent: Thursday, April 12, 2001 3:13 PM
> To: ADSM-L AT VM.MARIST DOT EDU
> Subject: Re: Dr. Watson in NT after installing TSM4.1
>
> Did you use the original OPT file? If so, there are some options that can
> cause Dr Watson errors. They are options that are no longer supported by
> the newer client, we have experienced this issue also and found this
> cause.
>
> -----Original Message-----
> From: Gottfried Scheckenbach
> [mailto:gottfried.scheckenbach AT xtelligent DOT de]
> Sent: Thursday, April 12, 2001 11:24 AM
> To: ADSM-L AT VM.MARIST DOT EDU
> Subject: Re: Dr. Watson in NT after installing TSM4.1
>
>
> Because there where no answers:
>
> Today I had the same problem - after upgrading a old ADSM 3.1 to TSM 4.1
> installation on NT with SP 3. Just after installation of SP 6 all went
> fine.
>
> Regards,
> Gottfried
>
>
> Shekhar Dhotre wrote:
> >
> > Hi all ,
> >
> > I installed TSM server 4.1 on WINNT 4.0 service pack 4 , RAM 256 MB
> > whenever i open configuration wizard to configure any of the
> parameters in
> > TSM
> > DR. WATSON shows his face .. what should i check to correct this
> problem ..
> >
> > Thanks
> > shekhar
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- Re: Dr. Watson in NT after installing TSM4.1, Gottfried Scheckenbach
- Re: Dr. Watson in NT after installing TSM4.1, Miller, Ryan
- Re: Dr. Watson in NT after installing TSM4.1,
LeBlanc, Patricia <=
- Re: Dr. Watson in NT after installing TSM4.1, Miller, Ryan
- Re: Dr. Watson in NT after installing TSM4.1, LeBlanc, Patricia
- Re: Dr. Watson in NT after installing TSM4.1, bbullock
- Re: Dr. Watson in NT after installing TSM4.1, Patricia LeBlanc
- Re: Dr. Watson in NT after installing TSM4.1, LeBlanc, Patricia
|
|
|