Re: Upgrade AIT -1 to AIT-2
2000-01-12 09:47:59
I was not involved with the original implementation, but our device class is
set to 8MM. Am I losing anything using AIT drives with this device class?
Jason Howard wrote:
> I have an ADIC Scalar 1000 with 4 AIT1 drives. I need to add at least 4
> new drives. I would like to replace my current 4 AIT1 drives for a
> total of 8 AIT2 Drives. What is the tape compatabilty between AIT1 and
> AIT2? Can I run 4 AIT 1 and 4 AIT2 drives in the same library accessing
> the same tapes?
>
> What are my options, and has anybody done this before?
>
> --
> Jason Howard
> Systems Adminstrator
> Blue Cross and Blue Shield of Alabama
> jhoward AT bcbsal DOT org
> PHONE 205-444-6203
> FAX 205-220-8503
> www.bcbsal.org
--
Jason Howard
Jason Howard
Systems Adminstrator
Blue Cross and Blue Shield of Alabama
jhoward AT bcbsal DOT org
PHONE 205-444-6203
FAX 205-220-8503
www.bcbsal.org
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- Upgrade AIT -1 to AIT-2, Jason Howard
- Re: Upgrade AIT -1 to AIT-2, Alan R. White
- Re: Upgrade AIT -1 to AIT-2, Jim Jepson
- Re: Upgrade AIT -1 to AIT-2, Remeta, Mark
- Re: Upgrade AIT -1 to AIT-2,
Jason Howard <=
- Re: Upgrade AIT -1 to AIT-2, Jason Howard
- Re: Upgrade AIT -1 to AIT-2, Remeta, Mark
- Re: Upgrade AIT -1 to AIT-2, Jordan, Chris (ELS)
- Re: Upgrade AIT -1 to AIT-2, Jim Jepson
- Re: Upgrade AIT -1 to AIT-2, Kristopher T. Domich
- Re: Upgrade AIT -1 to AIT-2, Jim Jepson [mailto:jepson
- Re: Upgrade AIT -1 to AIT-2, Jason Howard [mailto:jason.howard
- Re: Upgrade AIT -1 to AIT-2, Jason Howard [mailto:jason.howard
|
|
|