-
-
Community Tip: Forum Rules (PLEASE CLICK HERE TO READ BEFORE POSTING)
Click the link above to access ADSM.ORG Acceptable Use Policy and forum rules which should be observed when using this website. Violators may be banned from this website. This notice will disappear after you have made at least 3 posts.
VTL configuration in TSM
- Thread starter lotfi1986
- Start date
etchingsj
ADSM.ORG Member
Which storage solution?
Once the vendor SAN has been configured you should be able to define the VTL as you would any library/drives.
Once the vendor SAN has been configured you should be able to define the VTL as you would any library/drives.
Hello,
as far as I know EMC VNX 5300 is not a VTL, it is an unified storage box ... so if you have it as a VTL it is very likely you have a DataDomain box in front of it.
If it is so then you should see this document from EMC
http://www.datadomain.com/docs/emc/h8065-ibm-tsm-backup-data-domain-wp.pdf
In other case ... ignore this
Harry
as far as I know EMC VNX 5300 is not a VTL, it is an unified storage box ... so if you have it as a VTL it is very likely you have a DataDomain box in front of it.
If it is so then you should see this document from EMC
http://www.datadomain.com/docs/emc/h8065-ibm-tsm-backup-data-domain-wp.pdf
In other case ... ignore this
Harry
