During the processing of my daily maintenance I am issuing the following commands:
parallel
backup stg diskpool1 copypool1 process=4 wait=yes
backup stg diskpool2 copypool2 process=4 wait=yes
/* this is copying data from my primary disk pools to my copy pools
serial
parallel
backup stg tapepool1 copypool1 process=2 wait=yes
backup stg tapepool2 copypool2 process=2 wait=yes
/* this is catching anything that happened to overflow due to a triggered migration
serial
/* remaining maintenance commands are here
My question is regarding the "serial" stuck in the middle. I need the disk to tape copies to complete before the tape to tape copies begin. My assumption is that the serial command is needed to delimit the first two backup commands from the next two. Am I correct in this thinking?
Thanks much,
Bob
parallel
backup stg diskpool1 copypool1 process=4 wait=yes
backup stg diskpool2 copypool2 process=4 wait=yes
/* this is copying data from my primary disk pools to my copy pools
serial
parallel
backup stg tapepool1 copypool1 process=2 wait=yes
backup stg tapepool2 copypool2 process=2 wait=yes
/* this is catching anything that happened to overflow due to a triggered migration
serial
/* remaining maintenance commands are here
My question is regarding the "serial" stuck in the middle. I need the disk to tape copies to complete before the tape to tape copies begin. My assumption is that the serial command is needed to delimit the first two backup commands from the next two. Am I correct in this thinking?
Thanks much,
Bob