mikeatkc
ADSM.ORG Senior Member
I'm having difficulty installing the TS3310. I cannot seems to get past "system intializing" at any of the setup menu on the TS3310. I have open a ticket with IBM and after a week, the IBM field technician is at the same place where I was. The recommended solution was to tear the unit down and do hardware installation over (which I'm fine with). However, I like to get inputs to see if anyone else ran into issue with installing the TS3310.
Additionally, when powering up the TS3310, the I/O slots on the expansion modules do not lock and the robot/arm does not move up and down for testing.
TS3310 (5U) with two expansion modules (9U) on the bottom. The IBM technician did replaced the CF and the controller module.
All inputs are welcome, thank you.
Mike
Additionally, when powering up the TS3310, the I/O slots on the expansion modules do not lock and the robot/arm does not move up and down for testing.
TS3310 (5U) with two expansion modules (9U) on the bottom. The IBM technician did replaced the CF and the controller module.
All inputs are welcome, thank you.
Mike