Not able to Restore TSM serverFrom DB backup

[sus]

Hi,



I am running TSM serevr 5.3.2, unfortunatly my server crashed and i am trying to restore the server from the DB backup.Restoration went fine but after completing the restoarion of DB i am trying to run dsmserv.exe and it is doing the below process and hangs there...



Any body having any idea about this ......would be very helpfull if some one can help.



(C) Copyright IBM Corporation 1990, 2004.

All rights reserved.

U.S. Government Users Restricted Rights - Use, duplication or disclosure

restricted by GSA ADP Schedule Contract with IBM Corporation.



ANR4726I The ICC support module has been loaded.

ANR0990I Server restart-recovery in progress.

ANR0200I Recovery log assigned capacity is 2400 megabytes.

ANR0201I Database assigned capacity is 28800 megabytes.

ANR0306I Recovery log volume mount in progress.

ANR0285I Database page shadowing started using file dbpgshdw.bdt.

ANR0353I Recovery log analysis pass in progress.

ANR0354I Recovery log redo pass in progress.

ANR0355I Recovery log undo pass in progress.

 

[PJ]

You didn't say how long you've been waiting, but if your log is rather large and the server was under stress when it crashed, redo can take a ver long time. Longest I've seen was 8 hours with a 13GB log that was almost full and more than a thousand active sessions at the time it crashed. Watch disk and processor activity. It should access the log and db disks with a rather slow read/write thruput ob probably less than 1 MB/s and a couple hundred IO/s. If that's not the case and the box just sits there and does absolutely nothing, you could reformat the server before restore (you'll loose data) or call IBM.



Cheers

PJ