Plingy63
ADSM.ORG Member
Folks, I'm stuck. We recently installed a new LTO-3 [ADIC i2000] library with 6 LTO-3 drives. TSM was at 5.2.4. Backups from the TSM client seem fine... but when I subsequently try, for example, a MOVE DATA of that data to another tape, it just throws out constant "ANR8311E an I/O error occurred while accessing drive LTO12 (/dev/rmtx) for READ operation, errno=78" messages.
We upgraded the TSM fixpack level to 5.2.10.0...but the problem still persists.
I have defined the library as an Automated Library [SCSI]...I have defined the LTO device class as FORMAT=ULTRIUM. Still no joy.
The library is connected to an AIX host running AIX 5.3 ml2. We're using two hba's...going thru a Brocade 3800 to two blades at the back of the i2000. Each blade is connected to 3 drives...but with the first blade having the library autochanger mapped to it as well.
I realise TSM5.2 is out of support now, which is why I haven't logged a call yet... if anyone can think of anything I've setup incorrectly...or offer any advice that might lead to a solution, I'd be forever grateful. This is doing my head in! ;-)
We upgraded the TSM fixpack level to 5.2.10.0...but the problem still persists.
I have defined the library as an Automated Library [SCSI]...I have defined the LTO device class as FORMAT=ULTRIUM. Still no joy.
The library is connected to an AIX host running AIX 5.3 ml2. We're using two hba's...going thru a Brocade 3800 to two blades at the back of the i2000. Each blade is connected to 3 drives...but with the first blade having the library autochanger mapped to it as well.
I realise TSM5.2 is out of support now, which is why I haven't logged a call yet... if anyone can think of anything I've setup incorrectly...or offer any advice that might lead to a solution, I'd be forever grateful. This is doing my head in! ;-)