rbenavram
ADSM.ORG Member
1. How does TSM caculate how much capacity is left on a tape volume?
2. How does TSM know if hardware compression is enabled in the tape library/drive. How does hardware compression figure into the calculation of capacity?
3. If I do a "q vol tape_pooL status=full" why do "full" tapes (all of the same type) have different "estimated capacity"?
Thanks,
Richard
ADT
Boca Raton, FL
2. How does TSM know if hardware compression is enabled in the tape library/drive. How does hardware compression figure into the calculation of capacity?
3. If I do a "q vol tape_pooL status=full" why do "full" tapes (all of the same type) have different "estimated capacity"?
Thanks,
Richard
ADT
Boca Raton, FL