I am running Netbackup 3.4.1 on a Tape SAN with 9840 tape drives which was
working fine until a couple of weeks ago when one of the tape drives was
replaced.
Test backup after it was changed worked ok BUT since that time I have
discovered that although backups work ok if you try and restore from the
tape if fails
01:08:29 [745] <16> io_read_media_header: block read is not a NetBackup
media he
ader, len = 1024, media id Z00340, drive index 3, data is unknown
We had the engineer swap two drives, the failing drive and one we knew
worked ok, however the backup/restore problem stayed at the same location
while the swapped failing drive worked ok, so this seems to rule out the
hardware.
Any ideas please
Roger
***********************************************************************************
This message has been sent via the Internet. Internet communications are not
secure against interception or modification. Aseriti therefore cannot guarantee
that this message has not been modified in transit, and this message should not
be viewed as contractually binding.
This message and any files transmitted with it are confidential and intended
solely for the use of the addressee. If you have received this message in error
please notify the sender and destroy your copies of the message and any
attached files.
***********************************************************************************
Aseriti is the trading name of Severn Trent Systems Ltd.
Severn Trent Systems Ltd : a part of Severn Trent Plc
Registered in England and Wales Registration No. 2394552
|