[Networker] Faulty device status info
2006-11-27 09:20:46
I had an backup fail on me over the holiday weekend. This is on a
Sony PetaSite connected via fibre to a Sun Solaris 9 server. I think
the tape cartridge was faulty. The problem is, I can't seem to
convince NetWorker 7.2.1 to that this particular tape cartridge is no
longer receiving data. I used my tape library's GUI to remove that
tape, but NetWorker insists its still being written to, even though
the NetWorker GUI and "nsrjb -C" both indicate the tape drive in
question is not loaded with anything.
Does anyone have any tricks that would allow me to change the status
of this device so that I can use it again without shutting down the
NetWorker software or doing a reboot? I tried killing off the
relevant nsrmmd process, so perhaps that's what is causing this problem.
To sign off this list, send email to listserv AT listserv.temple DOT edu and type
"signoff networker" in the body of the email. Please write to networker-request
AT listserv.temple DOT edu if you have any problems with this list. You can access the
archives at http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- [Networker] Faulty device status info,
Stan Horwitz <=
|
|
|