[ADSM-L] TSM 6.1.3.1 on Windows?
2010-02-06 04:38:04
Hi,
Does anyone using TSM 6.1.3.1 on Windows Server 2008 R2?
I have a open support ticket where "Query SAN" showing the wrong information
and somehow does TSM Server try to take the wrong LTO Media to each Device
Classes.
After 24 hours are all my Scratch tapes in Private Mode?
What's happening is that I have a mix media in my Library with LTO-3 and LTO-4
tapes. But I only want to use LTO-4 to my primary tapepool and LTO-3 to my
Copypool.
I have create a BCKCLASS and COPYCLASS where BCKCLASS points to ULTRIUM4C and
COPYCLASS ULTRIUM3C
All LTO-3 Media starts with 0 and end with L3 and LTO-4 starts with A and ends
with L4.
When I run q libvol so will LTO-3 media be in the top and L4 media in the
bottom.
If I start a BACKUP STGPOOL to my Copypool does everything works fine in the
beginning. But when I start migration from DISKPOOL to TAPEPOOL then does TSM
try to mount a LTO-3 tape and failing and switch that media to Private, then it
continue with that until it gets to LTO-4 tapes and start migrate the data.
When I start the BACKUP STGPOOL again it does try to backup to a LTO-3 tape and
I get the same issue now with LTO-4 media that it put them in Private Mode.
Any guess why this is happening?
Best Regards
Christian Svensson
Cell: +46-70-325 1577
E-mail: Christian.Svensson AT cristie DOT se
Skype: cristie.christian.svensson
Supported Platform for CPU2TSM::
http://www.cristie.se/cpu2tsm-supported-platforms
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- [ADSM-L] TSM 6.1.3.1 on Windows?,
Christian Svensson <=
|
|
|