your device may support community string indexing.
Try:
  snmpwalk -c Community@VlanNumber YourSwitch .1.3.6.1.2.1.17.4.3.1
for example:
  snmpwalk -c public@100 YourSwitch .1.3.6.1.2.1.17.4.3.1

Hope this helps.

Kind regards

Oliver Bruchhaeuser
Tivoli NetView EMEA L2 Support




|---------+---------------------------->
|         |           jmfrancoz@soluzio|
|         |           na.com           |
|         |                            |
|         |           16.01.2003 10:12 |
|         |                            |
|---------+---------------------------->
  
>-----------------------------------------------------------------------------------------------------------------|
  |                                                                             
                                    |
  |       To:       nv-l AT lists.tivoli DOT com                                
                                           |
  |       cc:                                                                   
                                    |
  |       Subject:  [nv-l] MIB Switches                                         
                                    |
  |                                                                             
                                    |
  |                                                                             
                                    |
  
>-----------------------------------------------------------------------------------------------------------------|





Hi List::

Did anyone find in the past this strange situation?

Environment (Netview 7.1.3, Solaris 8)

Analysing MIB variables connected with general switches (dot1dBridge) I see
the following problem.

Checking the useful status variables (1- dot1dTpFdbAddress, 2-
dot1dTpFdbPort, 3- dot1dTpFdbStatus) of the mib table
(.1.3.6.1.2.1.17.4.3.1)
(.iso.org.dod.internet.mgmt.mib-2.dot1dBridge.dot1dTp.dot1dTpFdbTable.dot1dTpFdbEntry.dot1dTpFdbPort)


 We can only see the learned ports of the VLAN1 (default vlan). I can see
the other ports but just in "self" status not in "learned" state.

Therefore I can´t see the MAC of the computers join to the ports of the
oter defined VLAN´s.

I would be very grateful if anyone could explain me this situation.

Thanks a lot in advance:

José María



---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe AT lists.tivoli DOT com
For additional commands, e-mail: nv-l-help AT lists.tivoli DOT com

*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)





---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe AT lists.tivoli DOT com
For additional commands, e-mail: nv-l-help AT lists.tivoli DOT com

*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)