[Veritas-bu] Dual path tape drives
2009-03-10 13:02:32
Is there a way to configure the same tape drive on two fiber channels? I am
using Netbackup 6.0 MP6.
The way I have it set up now is the robot and half of the drives are set up on
one fiber path and the other half of the drives are set up on the other fiber
path. Can the robot and drives be seen by both fiber paths so if one goes down
the other can take over?
Thanks in advance.
+----------------------------------------------------------------------
|This was sent by jfairburn AT earthlink DOT net via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
|
|
|