Hello,
We make a backup product that uses Bacula as the backend. Our systems run Ubuntu v12.04 (kernel v3.12.17) with Bacula v5.2.12. Our product sets up the job resource definitions based on the user's choices, it validates the configuration with `bacula-dir -t`, and then it issues the bconsole `reload` command to load the new job resource. On a particular customer system, we find that the new job resource has not been loaded after the `reload` command has completed. If we give the `run` command, the new job is not in the list of jobs that can be executed. If we restart bacula-dir, then the job resource is loaded and it can be run. We haven't been able to figure out why `reload` isn't doing what we expect, so I hope that you can offer some advice. I have attached the Director configuration file from the affected system (bacula-dir.conf) and the file where we put the job resource definitions (jobs.conf), which is imported by the main configuration file.
I've found a few relevant points in researching this problem online. The bconsole documentation seems to discourage you from using `reload`:
"While it is possible to reload the Director's configuration on the fly, even while jobs are executing, this is a complex operation and not without side effects. Accordingly, if you have to reload the Director's configuration while Bacula is running, it is advisable to restart the Director at the next convenient opportunity."
Indeed, I have found that restarting the Director causes the new job resource to be loaded, but this is not a good solution for us because we often have many Bacula jobs running simultaneously; the "convenient" times when the Director could be restarted will be too infrequent.
I also found a closed bug ticket from a user who describes practically the same problem:
Thank you in advance for your help.
