I'm having a problem with a brand new Dell PV-124T Autochanger with  
LTO-3 tapes. Bacula's configuration files are commented very well and  
I'm reasonably certain that I've got the device configured properly as  
it passes btape test including the autochanger test. However, when I  
run any job, I get the following:

14-May 15:25 bluejay-sd: 3301 Issuing autochanger "loaded? drive 0"  
command.
14-May 15:25 bluejay-sd: 3302 Autochanger "loaded? drive 0", result:  
nothing loaded.
14-May 15:25 bluejay-sd: Invalid slot=0 defined, cannot autoload Volume.
14-May 15:25 bluejay-sd: Please mount Volume "Tape0001" on Storage  
Device "ULTRIUM-3" (/dev/tape) for Job bluejay.2008-05-14_15.25.52

I'm running CentOS 5.1 with the Bacula version available from EPEL  
(2.0.3). Thus far, I'm only trying to backup the machine the PV-124T  
is attached to.

Bacula is a fantastic piece of software (my test backups to files went  
flawlessly). I've searched the list archives looking for clues to a  
solution, but I can't find anything that seems to apply.

Thanks for any help,

Chip Warden



-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft 
Defy all challenges. Microsoft(R) Visual Studio 2008. 
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users