reading MIC on AIT using mtx and micinfo (from SONY)
2007-01-24 16:26:02
Does anyone happen to know how to make use of the MIC information on an
AIT tape (AIT5) using mtx?
I found something called micinfo at
http://www.sony.net/Products/storagesolution/documents/download03.html,
but it is a lengthy patch to mtx 1.2.11, and I find no updates. A google
search for "ait micinfo" turns up no other hits than the link above, and
micinfo all by itself gets a flood of audio stuff. It would seem that a
patch of that sort would certainly fail if applied to the current
version of mtx.
I'm using a SONY LIB162/A5BBLE, which is a 16 tape carousel changer with
one AIT5 drive and a barcode reader. I have mtx 1.2.17rel, and it seems
to work just fine. I'm on a Sun E250 running Solaris 9 using the sgen
driver. I can move tapes around, get info on the library, etc., using
mtx. It gives me the barcode information in the output. That's cool, but
it seems a shame not to use the MIC information as well.
I have also set up the st driver for the tape, and can successfully
access that with mt and do ufsdump & ufsrestore.
I'm in the process of configuring amanda, assuming I will use
chg-zd-mtx, and will then begin to replace our antiquated
server-by-server backup system.
If I'm wasting time and this is a dead end for whatever reason, then
perhaps someone could fill me in on why. I'm not sure amanda would even
make use of the information or where it would plug it in if it did.
However, since we're working from open source, it seems it should be
possible.
Thank you,
---------------
Chris Hoogendyk
-
O__ ---- Systems Administrator
c/ /'_ --- Biology & Geology Departments
(*) \(*) -- 140 Morrill Science Center
~~~~~~~~~~ - University of Massachusetts, Amherst
<hoogendyk AT bio.umass DOT edu>
---------------
Erdös 4
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- reading MIC on AIT using mtx and micinfo (from SONY),
Chris Hoogendyk <=
|
|
|