from dmesg:

scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.8
        <Adaptec 2944 Ultra SCSI adapter>
        aic7880: Ultra Wide Channel A, SCSI Id=7, 16/253 SCBs

blk: queue c14f6214, I/O limit 4095Mb (mask 0xffffffff)
  Vendor: QUANTUM   Model: DLT7000           Rev: 245F
  Type:   Sequential-Access                  ANSI SCSI revision: 02
blk: queue c14f6414, I/O limit 4095Mb (mask 0xffffffff)
...
...
Attached scsi tape st0 at scsi0, channel 0, id 4, lun 0

modules.conf:

alias eth0 3c59x
alias eth1 3c59x
alias scsi_hostadapter aic7xxx
alias usb-controller usb-uhci

wab

-----Original Message-----
From: Joshua Baker-LePain [mailto:jlb17 AT duke DOT edu] 
Sent: Tuesday, March 30, 2004 11:25 AM
To: Byarlay, Wayne A.
Cc: amanda-users AT amanda DOT org
Subject: Re: tape device /dev/st0 not responding - RH9

On Tue, 30 Mar 2004 at 11:14am, Byarlay, Wayne A. wrote

> Problem with the RH9 config, is that it successfully reports setting 
> the Quantum as /dev/st0, but any attempts to do anything with it, 
> fail. "mt

Can you include the relevant lines from /var/log/messages (i.e. when
it's detected)?  What are the contents of /etc/modules.conf?  


-- 
Joshua Baker-LePain
Department of Biomedical Engineering
Duke University