its finished!

define tapetype unknown-tapetype {
    comment "just produced by tapetype prog (hardware compression on)"
    length 104017 mbytes
    filemark 532 kbytes
    speed 2894 kps
}

does that look right for LTO1?

Tom

> Tom Brown wrote:
> > I didn't give it an estimate no - If i were to would i estimate the
> > 'uncompressed' capacity, in this case 100gig?
>
> yes.
>
> >
> > I'm loathed to stop it now as its been running since yesterday afternoon
and
> > is currently
> >
> > Estimated time to write 2 * 1024 Mbyte: 174 sec = 0 h 2 min
>
> This means that *if* the capacity is 1 Gbyte, it would finish in 2
> minutes + some seconds.
>
> > wrote 3167649 32Kb blocks in 9687 files in 27409 seconds (short write)
> > wrote 2930929 32Kb blocks in 17898 files......
>
> It's almost finished... still about 9687*2 - 17989 files to go.
>
> >
> > so i think it might be nearly finished?
> >
>
> Just for curiosity, you can start it again afterwards with:
>
>    amtapetype -e 100g ...
>
> and see what the estimated run is.  You may kill it then, if you don't
> want to wait any longer.
>
>
> -- 
> Paul Bijnens, Xplanation                            Tel  +32 16 397.511
> Technologielaan 21 bus 2, B-3001 Leuven, BELGIUM    Fax  +32 16 397.512
> http://www.xplanation.com/          email:  Paul.Bijnens AT xplanation DOT com
> ***********************************************************************
> * I think I've got the hang of it now:  exit, ^D, ^C, ^\, ^Z, ^Q, F6, *
> * quit,  ZZ, :q, :q!,  M-Z, ^X^C,  logoff, logout, close, bye,  /bye, *
> * stop, end, F3, ~., ^]c, +++ ATH, disconnect, halt,  abort,  hangup, *
> * PF4, F20, ^X^X, :D::D, KJOB, F14-f-e, F8-e,  kill -1 $$,  shutdown, *
> * kill -9 1,  Alt-F4,  Ctrl-Alt-Del,  AltGr-NumLock,  Stop-A,  ...    *
> * ...  "Are you sure?"  ...   YES   ...   Phew ...   I'm out          *
> ***********************************************************************
>
>
>