Tom Brown wrote:
I didn't give it an estimate no - If i were to would i estimate the
'uncompressed' capacity, in this case 100gig?
yes.
I'm loathed to stop it now as its been running since yesterday afternoon and
is currently
Estimated time to write 2 * 1024 Mbyte: 174 sec = 0 h 2 min
This means that *if* the capacity is 1 Gbyte, it would finish in 2
minutes + some seconds.
wrote 3167649 32Kb blocks in 9687 files in 27409 seconds (short write)
wrote 2930929 32Kb blocks in 17898 files......
It's almost finished... still about 9687*2 - 17989 files to go.
so i think it might be nearly finished?
Just for curiosity, you can start it again afterwards with:
amtapetype -e 100g ...
and see what the estimated run is. You may kill it then, if you don't
want to wait any longer.
--
Paul Bijnens, Xplanation Tel +32 16 397.511
Technologielaan 21 bus 2, B-3001 Leuven, BELGIUM Fax +32 16 397.512
http://www.xplanation.com/ email: Paul.Bijnens AT xplanation DOT com
***********************************************************************
* I think I've got the hang of it now: exit, ^D, ^C, ^\, ^Z, ^Q, F6, *
* quit, ZZ, :q, :q!, M-Z, ^X^C, logoff, logout, close, bye, /bye, *
* stop, end, F3, ~., ^]c, +++ ATH, disconnect, halt, abort, hangup, *
* PF4, F20, ^X^X, :D::D, KJOB, F14-f-e, F8-e, kill -1 $$, shutdown, *
* kill -9 1, Alt-F4, Ctrl-Alt-Del, AltGr-NumLock, Stop-A, ... *
* ... "Are you sure?" ... YES ... Phew ... I'm out *
***********************************************************************
|