On Thu, 13 Mar 2003 at 2:09pm, Ron Bauman wrote
amlabel: writing label: Read-only file system
It's indeed very weird. Two possibilities:
1. Are you sure you are specifying the correct tapedevice in the amanda
configuration? There is no "file system" on a tape, maybe you
specified "file:..." or something. Investigate with:
amgetconf YourConfig tpchanger
amgetconf YourConfig tapedev
2. Do you have the drive allowed for variable blocksize? (of fixed at
32k is fine too). I've had some problems with reading/writing
tapes with incompatible blocksizes (but never seen "read-only").
Try it out with "dd obs=...". If that one works with blocksize,
it's something else.
--
Paul Bijnens, Xplanation Tel +32 16 397.511
Technologielaan 21 bus 2, B-3001 Leuven, BELGIUM Fax +32 16 397.512
http://www.xplanation.com/ email: Paul.Bijnens AT xplanation DOT com
***********************************************************************
* I think I've got the hang of it now: exit, ^D, ^C, ^\, ^Z, ^Q, F6, *
* quit, ZZ, :q, :q!, M-Z, ^X^C, logoff, logout, close, bye, /bye, *
* stop, end, F3, ~., ^]c, +++ ATH, disconnect, halt, abort, hangup, *
* PF4, F20, ^X^X, :D::D, KJOB, F14-f-e, F8-e, kill -1 $$, shutdown, *
* kill -9 1, Alt-F4, Ctrl-Alt-Del, AltGr-NumLock, Stop-A, ... *
* ... "Are you sure?" ... YES ... Phew ... I'm out *
***********************************************************************
|