Configure/Install
2003-02-07 11:30:20
Hi,
I need some help.
I was going through the install of Amanda 2.3.4 and during the Configure the
process errored out with the following line
configure: error: *** --user-USER is missing
Any ideas what I missed. I figured this is a minor issue and caused by an
oversight on my behalf
Thanks
Christopher Broadwater
PC/LAN Specialist
Victoria IS Department
10 New Road
East Providence, RI
02909
(401)-435-9220 X2273
-----Original Message-----
From: John [mailto:john AT keimel DOT com]
Sent: Friday, February 07, 2003 10:06 AM
To: amanda-users AT amanda DOT org
Subject: Re: The next tape Amanda expects to use is: a new tape
On Mon, Feb 03, 2003 at 01:07:51PM -0500, Joshua Baker-LePain wrote:
> On Mon, 3 Feb 2003 at 12:26pm, John wrote
>
> > *** A TAPE ERROR OCCURRED: [cannot overwrite active tape Daily01].
> > Some dumps may have been left in the holding disk.
> > Run amflush to flush them to tape.
> > The next tape Amanda expects to use is: a new tape.
> >
> > Is there a way to make it use the existing 7 remaining tapes instead of
> > throwing a new tape at it? It's mostly a time thing for getting a new
> > tape, but it'd be nice to be able to go on with the next tape in the
> > cycle.
>
> Change your tapecycle to match how many tapes you have.
Thank folks for the helpful tips. I've edited my amanda.conf to read 7
tapes. I've also removed the broken tape 4 out of my tapelist.
The trouble is that a cow-orker was making some edits and left some
amanda.conf files laying about. I ended up changing the wrong file a few
times. I've since smacked the cow-orker up side the head with an old 5G
ESDI hard drive. Left a nice mark ;) And now the extra amanda.conf
is removed from the server.
Thanks again list for the prompt help from everyone.
j
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- Configure/Install,
Chris Broadwater <=
|
|
|