Fellows,

We have a Scalar library with LTO4 which was initially configured with the
TSM device drivers; in order to utilize the drive level encryption function
we have had to move data to a vtl, delete the devs in TSM, install the IBM
device drivers (to support drive level encryption) on Sol10 and finally
redefine the devices to TSM.

My question is this: do we need to relabel all the LTO4 tapes? I'm imagining
that no, we do not, since a label-encrypted scratch vol could be picked up
for a non-encrypted pool.. but I just wanted to get the general consensus.

Cheers,
Matthew


This e-mail and any attachments are confidential and intended solely for the 
addressee and may also be privileged or exempt from disclosure under applicable 
law. If you are not the addressee, or have received this e-mail in error, 
please notify the sender immediately, delete it from your system and do not 
copy, disclose or otherwise act upon any part of this e-mail or its attachments.

Internet communications are not guaranteed to be secure or virus-free.
The Barclays Group does not accept responsibility for any loss arising from 
unauthorised access to, or interference with, any Internet communications by 
any third party, or from the transmission of any viruses. Replies to this 
e-mail may be monitored by the Barclays Group for operational or business 
reasons.

Any opinion or other information in this e-mail or its attachments that does 
not relate to the business of the Barclays Group is personal to the sender and 
is not given or endorsed by the Barclays Group.

Barclays Bank PLC.Registered in England and Wales (registered no. 1026167).
Registered Office: 1 Churchill Place, London, E14 5HP, United Kingdom.

Barclays Bank PLC is authorised and regulated by the Financial Services 
Authority.