[NV-L] Status/Config Polling of non-snmp nodes and netmon performance

Subject:

From:

"Hill, Channing" <CHill AT bbandt DOT com>

To:

Date:

Wed, 2 Aug 2006 10:38:47 -0400

Per previous posts and documentation, Netview will use ICMP only to poll NON-SNMP nodes for status. However, will it still try to perform a configuration check (which is done via SNMP) per snmp.conf's time intervals for "Configuration Polling Intervals".

I will probably be faced with adding several nodes to be monitored that will not support SNMP (security reasons). My concern/question is, would these non-SNMP nodes cause netmon to slow down waiting on SNMP to time out when it is restarted and it performs timed configuration checks. If I understand correctly, netmon will still check nodes for SNMP when it is restarted and during Configuration polling intervals.

Could someone please advise.

Thanks,
Channing Hill
EMS Analyst II
BB&T
(252) 246-3642

_______________________________________________
NV-L mailing list
NV-L AT lists.ca.ibm DOT com
Unsubscribe:NV-L-leave AT lists.ca.ibm DOT com
http://lists.ca.ibm.com/mailman/listinfo/nv-l (Browser access limited to 
internal IBM'ers only)

<Prev in Thread]

Current Thread

[Next in Thread>

Previous by Date:

FW: [NV-L] FrameWork Patch for NetView 7.1.4 upgrade install frombackup on AIX 5.2, Anvaj A B

Next by Date:

Re: [NV-L] Status/Config Polling of non-snmp nodes and netmon performance, James Shanks

Previous by Thread:

FW: [NV-L] FrameWork Patch for NetView 7.1.4 upgrade install frombackup on AIX 5.2, Anvaj A B

Next by Thread:

Re: [NV-L] Status/Config Polling of non-snmp nodes and netmon performance, James Shanks

Indexes:

[Date] [Thread] [Top] [All Lists]