nv-l

[nv-l] Pb with messages on NV 7.1.4

2005-08-26 10:04:46
Subject: [nv-l] Pb with messages on NV 7.1.4
From: Maxime TRANNOY <MTRANNOY AT fr.ibm DOT com>
To: nv-l AT lists.us.ibm DOT com
Date: Fri, 26 Aug 2005 16:01:52 +0200
Hello all,

I've just installed a new server with 7.1.4 FP3 on AIX.
As usual I use my addtrap script to add my specific traps
and check in the /C/trap.conf to see if the result was correct
%PM-4-ERR_DISABLE {1.3.6.1.4.1.9999} 6 8000 A 4 0 "Error Events"
$2
SDESC
[chars] error detected on [chars], putting [chars] in err-disable state.
EDESC

Then I send a trap to test my addtrap command.

The result in the trapd.log was correct

1125061147 2 Fri Aug 26 14:59:07 2005 Test device       A link-flap error
detected on Fa1/0/10, putting Fa1/0/10 in err-disable state

but on the control desk I did not see the message???? only the 2 field Test
Device A and the rest of the line is blank.

In the nvserd.log I found that the field msg  was empty. But normally with
my trap description msg field should be equal to $2. It was the normal
behaviour in 7.1.3?

08/26/05 14:59:07
TEC_ITS_BASE;source=nvserverd;sub_source=A;origin=10.10.4.51;hostname=test
Device;adapter_host=192.168.254.220;category=1;date="08/26/05
14:59:07";severity=CRITICAL;status=OPEN;msg="
";nv_enterprise=Cisco_Syslog;nv_generic=6;nv_specific=8000;nv_var1="PM-4-ERR_DISABLE";nv_var2="link-flap
 error detected on Fa1/0/10, putting Fa1/0/10 in err-disable state";END

Can someone explain me what is the problem and how can I my message back on
my GUI.

Cordialement.

Maxime TRANNOY
IGS - Network Delivery Support Center
Tel : +33 (0) 492 114 767
mailto:mtrannoy AT fr.ibm DOT com